Page 1 of 1
How do I do an under water base?
Posted: Sun Mar 19, 2006 3:40 pm
by Hyperdash
Well? and by that I mean that there is water around your base but not inside it.
Posted: Sun Mar 19, 2006 4:40 pm
by tabasco sauce
hmmm try making a model around the base then giving it the !water shader
Posted: Sun Mar 19, 2006 5:48 pm
by Patrickssj6
Would look ugly without foq and with foq it would go through the base.So basically impossible I think.
Posted: Sun Mar 19, 2006 7:37 pm
by p0lar_bear
YOu could try making the base model, then put it under a water/fog plane. Then on the underside of the base where the entrance would be, put another fog/water plane. Not sure how it would turn out, though you should most definitely use a sky that doesn't have atmospheric fog. When atmospheric fog and plane fog collide, anything under thew fog plane become totally opaque.
Posted: Mon Mar 20, 2006 5:00 pm
by Caboose{SE}
wish i knew that a while ago : /