Requesting help on a collision model (improvement)
Posted: Sun Oct 01, 2006 6:11 pm
http://www.halomods.com/forums/viewtopi ... b9ae2a1447
go there and check out: Simple Tutorial on Getting Flat Square Metal Panels
I have this collision model which I converted over to trial (copied the vertices measurements). I'm planning on using this collision model and its model to help make a "log mod".
The only problem I have is that the collision model has small "cracks" in it (along the sides of the model, the collision model is too short: if you touch the edges of the log, you go through the object)
I know this isn't because it's a conversion problem, because I tried the model with the full version and it still has the same problems. If anyone can help make the log more "whole" I would really appreciate it.
P.S. if someone wants me to post the hex data for it, I can do that.
go there and check out: Simple Tutorial on Getting Flat Square Metal Panels
I have this collision model which I converted over to trial (copied the vertices measurements). I'm planning on using this collision model and its model to help make a "log mod".
The only problem I have is that the collision model has small "cracks" in it (along the sides of the model, the collision model is too short: if you touch the edges of the log, you go through the object)
I know this isn't because it's a conversion problem, because I tried the model with the full version and it still has the same problems. If anyone can help make the log more "whole" I would really appreciate it.
P.S. if someone wants me to post the hex data for it, I can do that.