HaloMods "Classic" Read-only Archive

can u help me with the xored lancher cause when i open it on my xbox it gives me a choise of halo2 and then i press the a putton then it just flashes but nutin happend what do i do just turn off my xbox then load halo that i have on my hard drive and i found this tut

Ftp to your xbox and find the config_v1.5.inc and transfer it to /E/TDATA/4d530064/.




Then go to your app folder and create a new folder named Xored 2.2.




Now take the stuff that you got from the Xored_Mini_Laucher.rar.




They look like this. ^^

Then transfer it to the Xored 2.2 folder and it should end up like this.




Now that you finally have Xored Trainer Laucher on your xbox you can finally use it but some people may have a problem when trying to select where it says Halo 2 and the screen will just flash.

What you have to do is edit the xored.ini file.




So open up the .ini file and find where it says Trainer Path and #Trainers_Path.


Code:
# 1 trainer path only
Trainers_Path = "C:\Trainers"
#Trainers_Path = "C:\Trainers"



and switch it with

Code:
# 1 trainer path only
Trainers_Path = "E:\Apps\Xored 2.2\Trainers"
#Trainers_Path = "E:\Apps\Xored 2.2\Trainers"



and it still flashes can sum1 tell me what did i do wrong and what didnt i do

You must have the Xored 2.2 in a different apps folder in a different drive or you have the Xored 2.2 folder renamed to something else. Do you have the yelo.etm file in the Trainers folder of the Xored 2.2 folder?

i got it now it wont take picture do u have 2 enable it or ......????

...
yes.

Enable the Developers Mode and it will work.